Omegon M8x55 Screw for Finder Brackets

Omegon M8x55 Screw for Follow-up Rings: replacement system screw with rubber stopper

Follow-up rings are attached with three screw-type fasteners that center the tube of the viewfinder or follow-up lens. If one is lost in the dark, or the rubber stopper wears out, the follow-up lens will no longer be stable and your alignment will be lost.

This loose screw is the replacement. The rubber cap on the tip presses against the tube without causing a dent or scratch, and at the same time holds the screw in place through friction.

Features

• M8 threaded screw with a thread length of 34 mm
• Total length of 55 mm
• Rubber stopper protects the probe tube
• Aluminium with coating: light and corrosion resistant
• Comes as a separate screw

Compatibility

This size is common for Omegon follow-up rings. If in doubt, measure the thread diameter of your existing screw: M8 has an outer diameter of 8 mm. Also pay attention to the required length, as a screw that is too long protrudes from the inside.

Specifications

You can find more telescope parts for this brand on the Omegon brand page.